enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cutting tool material - Wikipedia

   en.wikipedia.org/wiki/Cutting_tool_material

   Cutting tool materials are materials that are used to make cutting tools which are used in machining (drill bits, tool bits, milling cutters, etc.) but not other cutting tools like knives or punches. Cutting tool materials must be harder than the material of the workpiece, even at high temperatures during the process.

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).

4. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...

5. High-speed steel - Wikipedia

   en.wikipedia.org/wiki/High-speed_steel

   High-speed steel (HSS or HS) is a subset of tool steels, commonly used as cutting tool material. It is superior to high-carbon steel tools in that it can withstand higher temperatures without losing its temper (hardness). This property allows HSS to cut faster than high carbon steel, hence the name high-speed steel.

6. Brace (tool) - Wikipedia

   en.wikipedia.org/wiki/Brace_(tool)

   Turning the spindle of the chuck in a clockwise direction tightens the drill bit in the chuck; turning counterclockwise loosens the bit for removal. A carpenter using a brace. In most modern braces, immediately behind the chuck is a three position gear release that allows ratcheting of the handle when in tight spots. Turning the gear release ...

7. Bar stock - Wikipedia

   en.wikipedia.org/wiki/Bar_stock

   There are four types of materials available: O-1 tool steel, A-2 tool steel, A-6 tool steel, and 1018 steel (low-carbon or low-carb steel). Lengths are either 18 or 36 in (457 or 914 mm) long, various widths up to 16 in (406 mm) are available, and thicknesses range from 1 ⁄ 64 to 2.875 in (0.40 to 73.03 mm).