Search results
Results from the WOW.Com Content Network
Managed switches have one or more methods to modify the operation of the switch. Common management methods include: a command-line interface (CLI) accessed via serial console , telnet or Secure Shell , an embedded Simple Network Management Protocol (SNMP) agent allowing management from a remote console or management station, or a web interface ...
An electrical drawing is a type of technical drawing that shows information about power, lighting, and communication for an engineering or architectural project.Any electrical working drawing consists of "lines, symbols, dimensions, and notations to accurately convey an engineering's design to the workers, who install the electrical system on the job".
Both in-band and out-of-band management are usually done through a network connection, but an out-of-band management card can use a physically separated network connector if preferred. A remote management card usually has at least a partially independent power supply and can switch the main machine on and off through the network.
A low-voltage switchboard A modern electric switchboard. An electric switchboard is a piece of equipment that distributes electric power from one or more sources of supply to several smaller load circuits.
Simplified single line diagram of a single-phase transfer switch to select either 'city' (utility) power or local generator power 3-phase Intelligent transfer switch. A transfer switch is an electrical switch that switches a load between two sources. Some transfer switches are manual, in that an operator effects the transfer by throwing a ...
Ladder logic was originally a written method to document the design and construction of relay racks as used in manufacturing and process control. [1] Each device in the relay rack would be represented by a symbol on the ladder diagram with connections between those devices shown.
Top level Configuration Management Activity model. Configuration management (CM) is a management process for establishing and maintaining consistency of a product's performance, functional, and physical attributes with its requirements, design, and operational information throughout its life.
MII has two signal interfaces: A Data interface to the Ethernet MAC, for sending and receiving Ethernet frame data. A PHY management interface, MDIO, used to read and write the control and status registers of the PHY in order to configure each PHY before operation, and to monitor link status during operation.