Search results
Results from the WOW.Com Content Network
The following example shows the separation of the network prefix and the host identifier from an address (192.0.2.130) and its associated / 24 subnet mask (255.255.255.0). The operation is visualized in a table using binary address formats.
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
Destination: Network destination of the route; mask Netmask: The netmask (subnet mask) associated with the network destination; Gateway: The forwarding or next hop IP address over which the set of addresses defined by the network destination and subnet mask are reachable; metric Metric: Integer cost metric (ranging from 1 to 9999) for the route
A subnet mask is a bitmask that encodes the prefix length associated with an IPv4 address or network in quad-dotted notation: 32 bits, starting with a number of 1-bits equal to the prefix length, ending with 0-bits, and encoded in four-part dotted-decimal format: 255.255.255.0. A subnet mask encodes the same information as a prefix length but ...
The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
A shortcut to this process (for common masks using only 0 and 1 bit placements) is to simply take the host's IP address and set all bits in the host identifier portion of the address (any bit positions which hold a 0 in the subnet mask) to 1. As shown in the example below, in order to calculate the directed broadcast address to transmit a ...
When packets are sent over a network, the destination IP address is examined. If the destination IP is outside of the network, then the packet goes to the gateway for transmission outside of the network. The gateway is on the same network as end devices. The gateway address must have the same subnet mask as host devices. Each host on the ...