Search results
Results from the WOW.Com Content Network
A sectioned MGB showing the rear axle and differential. Early MGBs used the "banjo" type differential carried over from the MGA with the rear axle ratio reduced from the MGA's 4.1 (or 4.3) to 3.9 to 1. (Compensating for the reduction from 15 inch to 14-inch (360 mm) wheels). MGB GTs first began using a tube-type rear axle in 1967.
CMVs are restricted by gross weight (total weight of vehicle and cargo), and by axle weight (i.e., the weight carried by each tire). The federal weight limits for CMVs are 80,000 pounds (36,000 kg) for gross weight (unless the bridge formula dictates a lower limit), 34,000 pounds (15,000 kg) for a tandem axle, and 20,000 pounds (9,100 kg) for a ...
Standard wheeled vehicles are designated by the same MLC numbers (4 through 150), which correspond to about 85% of the gross weight in short tons. Each standard wheeled vehicle is defined in terms of gross weight, number of axles , axle spacing, and axle load.
It was a body-on-frame design, and suspension was independent with coil springs and wishbones at the front and a rigid axle with semi-elliptic springs at the rear. Steering was by rack and pinion . The car was available with either wire-spoked or steel-disc road wheels.
The standard rail weight for British railways is now 113 lb/yd (56.1 kg/m). Before the 1990s, most diesel locomotives were built to a maximum axle load of 19 long tons (19.3 tonnes; 21.3 short tons) so the maximum locomotive weight was 76 long tons (77.2 tonnes; 85.1 short tons) for a four-axle locomotive and 114 long tons (115.8 tonnes; 127.7 short tons) for a six-axle one.
Overlength limits vary depending on the type and the configuration of vehicle, but the overall maximum forward distance (i.e. the length from the front of the vehicle to the centre axis of the rear axle set) is 9.5 m (31 ft 2 in), the overall maximum single vehicle length is 12.6 m (41 ft 4 in) (some buses can be longer), and the overall ...
The 6×6 chassis are 9/14 ton (8,165/12,701 kg) on-/off-road rated, while the two 8×8 prototypes are rated at 16.5 tons (14,967 kg) and 15,000 kg payload. Both 8×8 chassis are fitted with a tridem rear axle layout, the rear axles (of which axles three and four steer) sprung hydraulically. [15] [16]
Curb weight (American English) or kerb weight (British English) is the total mass of a vehicle with standard equipment and all necessary operating consumables such as motor oil, transmission oil, brake fluid, coolant, air conditioning refrigerant, and sometimes a full tank of fuel, while not loaded with either passengers or cargo.