enow.com Web Search

  1. Ads

    related to: glass railing standoff fittings for boats and parts store

Search results

  1. Results from the WOW.Com Content Network
  2. Dutchman (repair) - Wikipedia

    en.wikipedia.org/wiki/Dutchman_(repair)

    A rail repair dutchman is typically a 4–6-inch (100–150 mm) long piece of rail that is cut in advance for the purpose and carried by a section crew. If the gang finds a rail with a chipped or broken end, they remove the connector plates ( fishplates ), cut out the damaged section, replace it with the dutchman, and bolt the connectors back ...

  3. Cable railing - Wikipedia

    en.wikipedia.org/wiki/Cable_railing

    Cable can have too much deflection allowing body parts to slip through, or cables can merely "pull out" of the end fittings, causing the cable rail to fail. Poorly designed end posts will result in a railing where the cables cannot be properly tensioned without an unacceptable amount of cable deflection.

  4. Spacers and standoffs - Wikipedia

    en.wikipedia.org/wiki/Spacers_and_standoffs

    Two sizes of metal standoffs and one plastic standoff. The background depicts a standoff in use, holding a circuit board above a metal case. A standoff is a threaded separator of defined length used to raise one part in an assembly above another. They are usually round or hex (for wrench tightening), often made of stainless steel, aluminum ...

  5. Boat building - Wikipedia

    en.wikipedia.org/wiki/Boat_building

    This can produce stronger parts with more glass and less resin, but takes special materials and more technical knowledge. Older fibreglass boats before 1990 were often not constructed in controlled temperature buildings leading to the widespread problem of fibreglass pox, where seawater seeped through small holes and caused delamination.

  6. Ground glass joint - Wikipedia

    en.wikipedia.org/wiki/Ground_glass_joint

    Crude versions of conically tapered ground glass joints have been made for quite a while, [1] particularly for stoppers for glass bottles and retorts. [2] Crude glass joints could still be made to seal well by grinding the two parts of a joint against each other using an abrasive grit, but this led to variations between joints and they would not seal well if mated to a different joint.

  7. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  1. Ads

    related to: glass railing standoff fittings for boats and parts store