Search results
Results from the WOW.Com Content Network
In computer networking, the maximum transmission unit (MTU) is the size of the largest protocol data unit (PDU) that can be communicated in a single network layer transaction. [1]: 25 The MTU relates to, but is not identical to the maximum frame size that can be transported on the data link layer, e.g., Ethernet frame.
Thus, the encapsulation overhead is the size of the IPv4 header of 20 bytes. On Ethernet with a maximum transmission unit (MTU) of 1500 bytes, IPv6 packets of 1480 bytes may therefore be transmitted without fragmentation. 6in4 tunneling is also referred to as proto-41 static because the endpoints are
The process is repeated until the MTU is small enough to traverse the entire path without fragmentation. As IPv6 routers do not fragment packets, there is no Don't Fragment option in the IPv6 header. For IPv6, Path MTU Discovery works by initially assuming the path MTU is the same as the MTU on the link layer interface where the traffic originates.
IP in IP is an IP tunneling protocol that encapsulates one IP packet in another IP packet. To encapsulate an IP packet in another IP packet, an outer header is added with Source IP, the entry point of the tunnel, and Destination IP, the exit point of the tunnel.
Many other transition mechanisms use tunneling to encapsulate IPv6 traffic within IPv4 networks and vice versa. This is an imperfect solution, which reduces the maximum transmission unit (MTU) of a link and therefore complicates Path MTU Discovery , and may increase latency .
The option value is derived from the maximum transmission unit (MTU) size of the data link layer of the networks to which the sender and receiver are directly attached. TCP senders can use path MTU discovery to infer the minimum MTU along the network path between the sender and receiver, and use this to dynamically adjust the MSS to avoid IP ...
The TCP should ask the IP for the Maximum Datagram Data Size (MDDS). This is the MTU minus the IP header length (MDDS = MTU − IPHdrLen). When opening a connection, TCP can send an MSS option with the value equal to: MDDS − TCPHdrLen. In other words, the MSS value to send is: MSS = MTU − TCPHdrLen − IPHdrLen
As there are only two endpoints on a tunnel, the tunnel is a point-to-point connection and PPP is a natural choice as a data link layer protocol between the virtual network interfaces. PPP can assign IP addresses to these virtual interfaces, and these IP addresses can be used, for example, to route between the networks on both sides of the tunnel.