Search results
Results from the WOW.Com Content Network
Schematic of a DCT (using two identical clutches located on the axis of the flywheel) A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1]
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
The operation of a dual-clutch transmission is analogous to two traditional manual transmissions, each with its own clutch, operating in parallel and alternating shifts. The Ford unit is a six-speed with one clutch acting on reverse, first, third, and fifth gears, and the other used for second, fourth, sixth gears.
Schematic of a DCT. A dual-clutch transmission (DCT, sometimes referred to as a twin-clutch transmission, or double-clutch transmission) uses two separate clutches for odd and even gear sets. [37] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as one unit.
It is marketed variously under the trade names TCT - Twin Clutch Transmission , Euro Twin Clutch Transmission , [2] TCSS - The Twin Clutch System [3] and Dual-Dry-Clutch Auto Transmission . Able to receive torque inputs of up to 350 N⋅m (260 lbf⋅ft), the transmission is the highest-torque transverse dual-dry-clutch application.(2012) [ 4 ...
Honda's older transmissions such as the Hondamatic semi-automatic transmission and its successors use traditional, individual gears on parallel axes like a manual transmission, with each gear ratio engaged by a separate hydraulic clutch pack. This design is also noteworthy because it preserves engine braking by eliminating a sprag between first ...
The transaxle configuration combines the gearbox and final drive in one housing and is only built in individual cases; In the transverse direction, the gearbox and final drive are very often combined in one housing due to the much more restricted space available; Every type of transmission occurs in every type of installation.
After its introduction in 1984, the Justy was also available with 4WD and thus a different gearbox. The gear ratios for this gearbox were altered slightly. In 1994 the normal/FWD gearbox was dropped; one could only get a 4WD gearbox by then. Gear ratios: 1st 3.071 2nd 1.695 3rd 1.137 4th .771 5th .631, Rev 3.461 Final 5.200