Search results
Results from the WOW.Com Content Network
Owned by the Electrical Regulatory Authorities Council (ERAC) – the peak body of electrical safety regulators in Australia and New Zealand – and the ACMA, RCM use is defined by AS/NZS 4417. [7] [8] On 1 March 2016, the RCM became mandatory and replaced ACMA's A-tick and C-tick marks. [9]
Chapter 1 contains standards that apply to all foods, including labelling requirements, additives, contaminants, genetically modified foods. All the standards in this chapter apply to both Australia and New Zealand, except for Standards 1.4.2 (Agvet chemicals) and 1.6.2 (Processing requirements for meat), which apply to Australia only.
An analysis of the price of a standards document to an end user, was that 40% was ascribed to the cost of sending the PDF document, [5] 54% was a royalty payable to the distributor (SAI Global), and 6% was a royalty to the IP owner (Standards Australia). [5] The price of standards document in Australia has been seen, by some industry observers ...
Pages in category "Standards of Australia" The following 9 pages are in this category, out of 9 total. This list may not reflect recent changes. A. AS 8015;
Pages in category "Standards of Australia and New Zealand" The following 6 pages are in this category, out of 6 total. This list may not reflect recent changes. A.
Round 7-pin trailer connector Type 1, Australian Standard 2513. In this pinout for an ISO 1724 connector, the position light pin is used for electric brakes (Pin 5, 58R), which means that if you connect a trailer with electric brakes to a towing vehicle wired according to ISO 1724 and turn on the position lights the trailer will be braking. Pin ...
In 2000, Standards Australia issued a system Standard AS60038, with 230 V as the nominal voltage with a +10% to −6% variation at the point of supply, i.e., 253 V to 216.2 V. A new power quality standard, AS 61000.3.100, was released in 2011 [25] that details additional requirements.
This Standard was originally published in 1931 as CB1 - SAA Boiler Code. It was subsequently issued in 1963 and 1967. In 1972, the Standard was issued under the designation AS 1200. The 2nd, 3rd and 4th editions were published in 1978, 1981 and 1988 respectively. In 1994 the Standard was jointed revised and issued under the designation AS/NZS 1200.