Search results
Results from the WOW.Com Content Network
HC-12a, also called ES-12a, OZ-12a, DURACOOL 12a [1] and Hydrocarbon Blend B, is marketed as a "drop-in" replacement refrigerant for R-12 and other refrigerants. HC-12a is a mixture of hydrocarbons, specifically propane (R-290) and isobutane (R-600a), and is therefore considered nearly non-ozone-depleting.
Pentafluoroethane in a near azeotropic mixture with difluoromethane is known as R-410A, a common replacement for various chlorofluorocarbons (commonly known as Freon) in new refrigerant systems. Fire suppression systems
[19]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.
The same fitting can be used in reverse as an eccentric increaser or expander. They are used where the diameter of the pipe on the upstream side of the fitting (i.e. where flow is coming from) is larger than the downstream side, and where there is a danger that vapour may accumulate. [1]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
This refrigerant was designed as a drop-in replacement for dichlorodifluoromethane (R-12) which is compatible with the typical mineral oil lubricants used in R-12 systems. Since it is a zeotropic mixture , it has a range of boiling points which may increase the effectiveness of the heat transfer elements in refrigeration equipment.
Perez, the girl’s mother, allegedly told police they placed the toddler in her crib around 7 p.m. the night before with a space heater turned as high as it could be set and did not check on her ...
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect