Search results
Results from the WOW.Com Content Network
General 3.5 mm computer headsets come with two 3.5 mm connectors: one connecting to the microphone jack and one connecting to the headphone/speaker jack of the computer. 3.5 mm computer headsets connect to the computer via a sound card, which converts the digital signal of the computer to an analog signal for the headset. USB computer headsets ...
Spill occurs when sound is detected by a microphone not intended to pick it up (for example, the vocals being detected by the microphone for the guitar). [3] Spill is often undesirable in popular music recording, [4] as the combined signals during the mix process can cause phase cancellation and may cause difficulty in processing individual tracks. [2]
A pistonphone is an acoustical calibrator (sound source) that uses a closed coupling volume to generate a precise sound pressure for the calibration of measurement microphones. The principle relies on a piston mechanically driven to move at a specified cyclic rate, pushing on a fixed volume of air to which the microphone under test is coupled.
Microphones on stands are also placed in front of instrument amplifiers to pick up the sound. Headset-mounted and tie-clip-mounted microphones are often used with wireless transmission to allow performers or speakers to move freely. Early adopters of headset mounted microphones technology included country singer Garth Brooks, [6] Kate Bush, and ...
Generally, line level signals sit in the middle of the hierarchy of signal levels in audio engineering. There are weaker signals such as those from microphones (Mic Level/Microphone Level) and instrument pickups (Instrument Level), and stronger signals, such as those used to drive headphones and loudspeakers (Speaker Level).
Active noise-cancelling headphones use a microphone, amplifier, and speaker to pick up, amplify, and play ambient noise in phase-reversed form; this to some extent cancels out unwanted noise from the environment without affecting the desired sound source, which is not picked up and reversed by the microphone. They require a power source ...
Block diagram of the signal-flow for a common feedback loop [1]: 118 . Audio feedback (also known as acoustic feedback, simply as feedback) is a positive feedback situation that may occur when an acoustic path exists between an audio output (for example, a loudspeaker) and its audio input (for example, a microphone or guitar pickup).
A conventional microphone placed on, or a few inches above, a hard boundary surface will pick up the desired direct sound as well as delayed sound reflecting off the boundary surface. The direct and delayed reflected sounds will combine at the microphone to create comb filtering , with constructive and destructive interference causing peaks and ...