Search results
Results from the WOW.Com Content Network
0.3048 m. 30.48 cm. 304.8 mm. The foot (standard symbol: ft) [1][2] is a unit of length in the British imperial and United States customary systems of measurement. The prime symbol, ′, is commonly used to represent the foot. [3] In both customary and imperial units, one foot comprises 12 inches, and one yard comprises three feet.
In radar -related subjects and in JTIDS, a data mile is a unit of distance equal to 6,000 feet (1,829 metres; 0.9875 nautical miles; 1.136 miles). An international mile is 0.88 data mile. The speed of light is 299,792,458 metres per second (983,571,056 ft/s), or about one foot per nanosecond. If it were exactly one foot per nanosecond, and a ...
A nautical mile is a unit of length used in air, marine, and space navigation, and for the definition of territorial waters. [2] [3] [4] Historically, it was defined as the meridian arc length corresponding to one minute ( 1 / 60 of a degree) of latitude at the equator, so that Earth's polar circumference is very near to 21,600 nautical miles (that is 60 minutes × 360 degrees).
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
The metre (or meter in US spelling; symbol: m) is the base unit of length in the International System of Units (SI). Since 2019, the metre has been defined as the length of the path travelled by light in vacuum during a time interval of 1 / 299 792 458 of a second, where the second is defined by a hyperfine transition frequency of caesium.
Therefore, a pressure altitude of 32,000 ft (9,800 m) is referred to as "flight level 320". In metre altitudes the format is Flight Level xx000 metres. Flight levels are usually designated in writing as FLxxx, where xxx is a two- or three-digit number indicating the pressure altitude in units of 100 feet (30 m). In radio communications, FL290 ...
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.
These are the defining dimensions for NAD 27, but Clarke actually defined his 1866 spheroid as a = 20,926,062 British feet, b = 20,855,121 British feet. The conversion to meters uses Clarke's 1865 inch-meter ratio of 39.370432. The length of a foot or meter at the time could not practically be benchmarked to better than about 0.02 mm. [11]