enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Insert nut: Threaded socket A threaded socket for a wooden workpiece, similar to a wall anchor. Knurled nut: Thumb nut Has a knurled outside surface which facilitates tightening by hand (thumb nut) or secures the nut into a handle or cover (insertion nut) Sex bolt: Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or ...

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   A socket cap screw, also known as a socket head capscrew, socket screw, or Allen bolt, is a type of cap screw with a cylindrical head and hexagonal drive hole. The term socket head capscrew typically refers to a type of threaded fastener whose head diameter is nominally 1.5 times that of the screw shank ( major ) diameter, with a head height ...

4. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   These are designed to engage with the tool used to tighten them. Some bolt heads instead lock the bolt in place, so that it does not move and a tool is only needed for the nut end. Common bolt heads include hex, slotted hex washer, and socket cap. The first bolts had square heads, formed by forging. These are still found, although much more ...

5. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.

6. Nut driver - Wikipedia

   en.wikipedia.org/wiki/Nut_driver

   A nutdriver or nut driver is a hand tool for tightening or loosening nuts and bolts. It essentially consists of a socket attached to a shaft and cylindrical handle and is similar in appearance and use to a screwdriver. [1] They generally have a hollow shaft to accommodate a shank onto which a nut is threaded.

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...