Search results
Results from the WOW.Com Content Network
The amplifier featured five valves and an output of 10 watts - hence '5-10'. Of those valves, one was a full-wave rectifier (an EZ80 or EZ81), one was a pre-amplifier pentode EF86 and one a double-triode ECC83 as phase splitter. The power amplification was handled by a pair of EL84 working in push-pull configuration.
A proportional controller schematic is shown here. The set point is transmitted through the flapper plate via the fulcrum to close the orifice and increase the chamber pressure. The feedback bellows resists and the output signal goes to the control valve which opens with increasing actuator pressure.
This makes them unsuitable for use with valve amplifiers, particularly lower-power single-ended designs. Valve hi-fi power amplifier designs since the 1970s have had to move mainly to class AB1 push–pull (PP) circuits. Tetrodes and pentodes, sometimes in ultra-linear configuration, with significant negative feedback, are the usual configuration.
Schematic symbol used in circuit diagrams for a vacuum tube, showing control grid. The control grid is an electrode used in amplifying thermionic valves (vacuum tubes) such as the triode, tetrode and pentode, used to control the flow of electrons from the cathode to the anode (plate) electrode. The control grid usually consists of a cylindrical ...
Mullard Circuits for Audio Amplifiers is a famous book by the Technical Services Department of Mullard Ltd, a British valve manufacturing company. First published in 1959 and then reprinted several times it contained a number of designs by Mullard engineers for high quality audio amplifiers, which were to be used by amateur constructors as well as by manufacturers as the basis for many ...
A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.
Circuit symbol of a heptode. The development of the pentagrid or heptode (seven-electrode) valve was a novel development in the mixer story. The idea was to produce a single valve that not only mixed the oscillator signal and the received signal and produced its own oscillator signal at the same time but, importantly, did the mixing and the oscillating in different parts of the same valve.
An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the magnitude of a signal (a time-varying voltage or current). It is a two-port electronic circuit that uses electric power from a power supply to increase the amplitude (magnitude of the voltage or current) of a signal applied to its input ...