enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wood glue - Wikipedia

   en.wikipedia.org/wiki/Wood_glue

   Liquid versions of hide glue are now available; typically they have urea added to keep the glue liquid at room temperature and to extend drying time. Examples of liquid hide glue are Old Brown Glue or Titebond Liquid Hide. Hide glue does not creep. Hide glue joints are easy to repair, by just heating and adding more hide glue. [7] [8] [9]

3. List of glues - Wikipedia

   en.wikipedia.org/wiki/List_of_glues

   Once wet, 6–7 hours. ~4 hours for softwood, 8 for hardwood; must be under pressure for >0.5-2 hrs tensile strength exceeds most woods, 2,200-3,00 pounds per square inch water-resistant, depending on alkalis used Woodworking, paper glue, fireproof laminates Medieval or earlier Soybean glue: As for casein glue, but using soy protein

4. Pressure-sensitive adhesive - Wikipedia

   en.wikipedia.org/wiki/Pressure-sensitive_adhesive

   Styrene block copolymers (SBC), also called styrene copolymer adhesives and rubber-based adhesives, have good low-temperature flexibility, high elongation, and high heat resistance. They are frequently used in hot melt adhesive applications, where the composition retains tack even when solidified; however non-pressure-sensitive formulations are ...

5. Hot-melt adhesive - Wikipedia

   en.wikipedia.org/wiki/Hot-melt_adhesive

   The bonding temperature is lower than with most other HMAs, only about 50 °C (122 °F) to 70 °C (158 °F), when the adhesive behaves as a soft rubber acting as a pressure-sensitive adhesive. The surface wetting in this amorphous state is good, and on cooling the polymer crystallizes, forming a strong flexible bond with high cohesion.

6. J-B Weld - Wikipedia

   en.wikipedia.org/wiki/J-B_Weld

   The mixture sets in 4-6 hours and fully cures in up to 15 hours. It can be used as an adhesive, laminate, plug, filler, sealant, or electrical insulator and can be drilled, ground, tapped, machined, sanded, and painted when cured. J-B Kwik is a faster-curing two-part epoxy with medium-temperature resistance up to 300 °F (149 °C).

7. Chemistry of pressure-sensitive adhesives - Wikipedia

   en.wikipedia.org/wiki/Chemistry_of_pressure...

   Too low a temperature can cause the polymeric adhesive to enter its glass state becoming very brittle and reducing adhesion. [14] Raising the temperature, on the other hand, causes the polymer to become more fluid and mobile. As the mobility increases, the polymer adhesion is reduced as the polymer starts to flow as opposed to adhere.