Search results
Results from the WOW.Com Content Network
ATX motherboard power connector (usually called P1): This is the connector that goes to the motherboard to provide it with power. The connector has 20 or 24 pins. One of the pins belongs to the PS-ON wire (it is usually green). This connector is the largest of all the connectors. In older AT power supplies, this connector was split in two: P8 ...
Pages in category "Computer connectors" The following 52 pages are in this category, out of 52 total. This list may not reflect recent changes. ...
Examples of computer connector sockets on various laptops Ports on the back of the Apple Mac Mini (2005) A computer port is a hardware piece on a computer where an electrical connector can be plugged to link the device to external devices, such as another computer, a peripheral device or network equipment. [1] This is a non-standard term.
In computer hardware, a CPU socket or CPU slot contains one or more mechanical components providing mechanical and electrical connections between a microprocessor and a printed circuit board (PCB). This allows for placing and replacing the central processing unit (CPU) without soldering.
PC/104 is an embedded computer standard which defines both a form factor and computer bus. PC/104 is intended for embedded computing environments. Single-board computers built to this form factor are often sold by COTS vendors, which benefits users who want a customized rugged system, without months of design and paper work.
Starting with the 80-conductor cable defined for use in ATAPI5/UDMA4, the master Device 0 device goes at the far-from-the-host end of the 18-inch (460 mm) cable on the black connector, the slave Device 1 goes on the grey middle connector, and the blue connector goes to the host (e.g. motherboard IDE connector, or IDE card).
In addition, there are bus expansion cables which will extend a computer bus to an external backplane, usually located in an enclosure, to provide more or different slots than the host computer provides. These cable sets have a transmitter board located in the computer, an expansion board in the remote backplane, and a cable between the two.
The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches apart.