Search results
Results from the WOW.Com Content Network
Wire bonding is a method of making interconnections between an integrated circuit (IC) or other semiconductor device and its packaging during semiconductor device fabrication. Wire bonding can also be used to connect an IC to other electronics or to connect from one printed circuit board (PCB) to another, although these are less common. Wire ...
The die is glued or soldered to the die pad inside the lead frame, and then bond wires are attached between the die and the bond pads to connect the die to the leads in a process called wire bonding. In a process called encapsulation, a plastic case is moulded around the lead frame and die, exposing only the leads.
The individual chips are patterned with small pads of metal near their edges that serve as the connections to an eventual mechanical carrier. The chips are then cut out of the wafer and attached to their carriers, typically via wire bonding such as thermosonic bonding. These wires eventually lead to pins on the outside of the carriers, which ...
The following operations are performed at the packaging stage, as broken down into bonding, encapsulation, and wafer bonding steps. Note that this list is not all-inclusive and not all of these operations are performed for every package, as the process is highly dependent on the package type. IC bonding. Wire bonding; Thermosonic Bonding; Down ...
The figure shows the cross section of a flat no-lead package with a lead frame and wire bonding. There are two types of body designs, punch singulation and saw singulation. [3] Saw singulation cuts a large set of packages in parts. In punch singulation, a single package is moulded into shape.
Tape-automated bonding: Variation of COF, where a flip chip is mounted directly to a flex circuit without the use of bonding wires. Used by LCD driver ICs. COG: Chip-on-glass: Variation of TAB, where a chip is mounted directly to a piece of glass - typically an LCD. Used by LCD and OLED driver ICs.
In "wire bonding", the chip is attached to the board with an adhesive. Each pad on the device is connected with a fine wire lead that is welded to the pad and to the circuit board. This is similar to the way that an integrated circuit is connected to its lead frame, but instead the chip is wire-bonded directly to the circuit board. [3]
The resulting weld is quite different in appearance from the ball bond, and is referred to as the wedge bond, tail bond, or simply as the second bond. In the final step the machine pays out a small length of wire and tears the wire from the surface using a set of clamps. This leaves a small tail of wire hanging from the end of the capillary ...