enow.com Web Search

  1. Ads

    related to: needle valve vs flow control stem hydro rain 100 c in g

Search results

  1. Results from the WOW.Com Content Network
  2. Flow control valve - Wikipedia

    en.wikipedia.org/wiki/Flow_control_valve

    Control valves can also work with hydraulic actuators (also known as hydraulic pilots). These types of valves are also known as automatic control valves. The hydraulic actuators respond to changes of pressure or flow and will open/close the valve. Automatic control valves do not require an external power source, meaning that the fluid pressure ...

  3. Needle valve - Wikipedia

    en.wikipedia.org/wiki/Needle_valve

    Needle valves are also commonly used to provide shut off for the pressure gauge or on applicators to shut off the supply of NH3 to the knives in anhydrous ammonia (NH3) applications. [2] Since flow rates are low and many turns of the valve stem are required to completely open or close, needle valves are not used for simple shutoff applications.

  4. Control valve - Wikipedia

    en.wikipedia.org/wiki/Control_valve

    A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure , temperature , and liquid level.

  5. Hydraulic analogy - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_analogy

    Flow and pressure variables can be calculated in both steady and transient fluid flow situations with the use of the hydraulic ohm analogy. [ 3 ] [ 4 ] Hydraulic ohms are the units of hydraulic impedance, which is defined as the ratio of pressure to volume flow rate.

  6. Injector - Wikipedia

    en.wikipedia.org/wiki/Injector

    An injector is a system of ducting and nozzles used to direct the flow of a high-pressure fluid in such a way that a lower pressure fluid is entrained in the jet and carried through a duct to a region of higher pressure. It is a fluid-dynamic pump with no moving parts except a valve to control inlet flow.

  7. Hydronic balancing - Wikipedia

    en.wikipedia.org/wiki/Hydronic_balancing

    Control valves may temporarily help by gradually reducing the flow in favoured circuits, thus allowing unfavored circuits to achieve the correct flow. This will however cause long delays in reaching the set temperature in the building after night setback and will make the installation very inefficient.

  1. Ads

    related to: needle valve vs flow control stem hydro rain 100 c in g