enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Three different international-standard two-hole punches. A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves).

3. Loose leaf - Wikipedia

   en.wikipedia.org/wiki/Loose_leaf

   Five Star sells Letter-sized loose leaves; Oxford and Mead sell 8 x 10.5 inch loose leaves. In libraries and print shops, hole punchers are regularly provided for punching 3 holes. Some bound notebooks have perforated lines for tearing off pages, and all pages have pre-punched holes, so that when torn off, they can be organized into a binder ...

4. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   The distance from the punched holes to the nearest edge of the paper is less critical, since small differences do not affect the compatibility of paper and binder. Typical distance from the paper edge to the center of the hole is 0.5 inches (13 mm), and typical diameter of the hole ranges from 0.25 inches (6.4 mm) to 0.31 inches (7.9 mm) in ...

5. Stationery - Wikipedia

   en.wikipedia.org/wiki/Stationery

   Paper and pad: Notebooks, wirebound notebook, writing pads, college ruled paper, wide-ruled paper, Office paper: dot matrix paper, inkjet printer paper, laser printer paper, photocopy paper. Loose leaves, ring binders and hole punches. Writing instruments: ballpoint pen, fountain pen, pencil, porous point pen, rollerball pen, highlighter pen ...

6. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

7. Perforation - Wikipedia

   en.wikipedia.org/wiki/Perforation

   The punch and die are shaped to produce the desired shaped hole. The clearance (the distance between the outside circumference of the punch and the inner circumference of the die) must be properly maintained to ensure a clean cut. Burrs are produced on the side of the workpiece that is against the die. [1]