Search results
Results from the WOW.Com Content Network
During a rollover, or when a wave washes over the craft, its engine can hydrolock, though severe damage is rare due to the special air intakes and low rotating inertia of small marine engines. Inboard marine engines have a different vulnerability as these often have their cooling water mixed with the exhaust gases in the header to quiet the engine.
A bad crank position sensor can worsen the way the engine idles, or the acceleration behaviour. If the engine is revved up with a bad or faulty sensor, it may cause misfiring, motor vibration or backfires. Acceleration might be hesitant, and abnormal shaking during engine idle might occur. In the worst case, the car may not start.
The first advanced mechanical means of marine propulsion was the marine steam engine, introduced in the early 19th century. During the 20th century it was replaced by two-stroke or four-stroke diesel engines, outboard motors, and gas turbine engines on faster ships.
The original company that made Johnson inboard motors and outboard motors was the Johnson Brothers Motor Company of Terre Haute, Indiana, United States. They started building inboard 2-cycle marine engines in 1903 in a barn behind the house, along with matching boats. By 1908, they were making V4, V6, V8, and V12 aircraft and marine engines.
The outdrive unit of a boat with sterndrive. A sterndrive or inboard/outboard drive (I/O) is a form of marine propulsion which combines inboard power with outboard drive. The engine sits just forward of the transom while the drive unit (outdrive or drive leg) lies outside the hull.
A 16-horsepower (12 kW) inboard marine diesel engine, installed in a sailboat Engine room layout of a rescue boat An 11,100-horsepower (8,300 kW) 5-cylinder, 2-stroke, low-speed marine diesel engine, powering a ship. The first marine craft to utilize inboard motors were steam engines going back to 1805 and the Clermont and the Charlotte Dundas ...
Engines fitted with a decompressor can also be stopped by operating the decompressor, and in a vehicle with a manual transmission it is sometimes possible to stop the engine by engaging a high gear (i.e. 4th, 5th, 6th etc.), with foot brake and parking brake fully applied, and quickly letting out the clutch to slow the engine RPM to a stop ...
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.