Search results
Results from the WOW.Com Content Network
A bad crank position sensor can worsen the way the engine idles, or the acceleration behaviour. If the engine is revved up with a bad or faulty sensor, it may cause misfiring, motor vibration or backfires. Acceleration might be hesitant, and abnormal shaking during engine idle might occur. In the worst case, the car may not start.
With both inboards and stern drives there is a fire and explosion hazard from gasoline fuel vapors within the engine compartment. Typically these boats must run a blower for several minutes prior to starting the engine, and when idling or moving below cruise speed. The blower exchanges the air within the engine compartment with fresh outside air.
Slow speed: any engine with a maximum operating speed up to 300 revolutions per minute (rpm), although most large two-stroke slow speed diesel engines operate below 120 rpm. Some very long stroke engines have a maximum speed of around 80 rpm. The largest, most powerful engines in the world are slow speed, two stroke, crosshead diesels.
Idle speed, sometimes simply called "idle", is the rotational speed an engine runs at when the engine is idling, that is when the engine is uncoupled from the drivetrain and the throttle pedal is not depressed. In combustion engines, idle speed is generally measured in revolutions per minute (rpm) of the crankshaft.
Small boats with outboard engines and personal water crafts (PWC) tend to ingest water simply because they run in and around it. During a rollover, or when a wave washes over the craft, its engine can hydrolock, though severe damage is rare due to the special air intakes and low rotating inertia of small marine engines.
An inboard motor is a marine propulsion system for boats. As opposed to an outboard motor, where an engine is mounted outside the hull of the craft, an inboard motor is an engine enclosed within the hull of the boat, usually connected to a propulsion screw by a driveshaft. Marine diesel engines used in international shipping are the largest ...
The original company that made Johnson inboard motors and outboard motors was the Johnson Brothers Motor Company of Terre Haute, Indiana, United States. They started building inboard 2-cycle marine engines in 1903 in a barn behind the house, along with matching boats. By 1908, they were making V4, V6, V8, and V12 aircraft and marine engines.
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.