Search results
Results from the WOW.Com Content Network
The rear wheels are located transversely by top links and wheel carriers (green) and lower links (cyan). The top link is the driving half-shaft with a universal joint at each end. The lower link pivots adjacent to the differential casing at its inboard end and where it meets the wheel carrier at the wheel hub casting (violet) at its outboard end.
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
Full coilovers are matched up with a shock absorber from the factory, while with slip-on coilovers, the dampers and springs are bought separately and then assembled. [4] There are a large number of companies who make aftermarket coilovers for vehicles, many of which allow the customer to adjust various settings such as ride height and damping.
A driveshaft coupling. Note the split damage beginning to appear, likely due to the large axial displacement. A giubo. A giubo (/ ˈ dʒ uː b oʊ / JOO-boh; etymology: giunto Boschi, "Boschi joint"), also known as a 'flexdisc', and sometimes misspelled as guibo, is a flexible coupling used to transmit rotational torque between the drive shaft and the companion flange on mechanical devices ...
Differential unit for a rear-wheel drive car, built by ZF c. 2004 Differential gears (in yellow) in a punched tape reader, built by Tally c. 1962 A differential is a gear train with three drive shafts that has the property that the rotational speed of one shaft is the average of the speeds of the others.
The Herald, Vitesse, Spitfire, and GT6 all used a rear transverse leaf spring, as well as the 1995-98 Volvo 960/S90/V90 and a rare Swedish sports car incorporating the Volvo 960 rear suspension called the JC Indigo. [1]: 4 This type of suspension should not be confused with earlier, rigid axle applications such as those used on early Ford cars.
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.
Camber angle is one of the angles made by the wheels of a vehicle; specifically, it is the angle between the vertical axis of a wheel and the vertical axis of the vehicle when viewed from the front or rear. It is used in the creation of steering and suspension.