Search results
Results from the WOW.Com Content Network
In geology, the term compression refers to a set of stresses directed toward the center of a rock mass. Compressive strength refers to the maximum amount of compressive stress that can be applied to a material before failure occurs.
In geology, the term "tension" refers to a stress which stretches rocks in two opposite directions. The rocks become longer in a lateral direction and thinner in a vertical direction. One important result of tensile stress is jointing in rocks.
A tension member is a structural element designed to carry loads primarily through tensile forces, meaning it is subjected to stretching rather than compression or bending. These members are integral components in engineering and architectural structures, such as trusses , bridges , towers, and suspension systems, where they provide stability ...
Tension is the pulling or stretching force transmitted axially along an object such as a string, rope, chain, rod, truss member, or other object, so as to stretch or pull apart the object. In terms of force, it is the opposite of compression. Tension might also be described as the action-reaction pair of forces acting at each end of an object.
In other contexts one may be able to reduce the three-dimensional problem to a two-dimensional one, and/or replace the general stress and strain tensors by simpler models like uniaxial tension/compression, simple shear, etc. Still, for two- or three-dimensional cases one must solve a partial differential equation problem.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The amount of stretch or compression along material line elements or fibers is the normal strain, and the amount of distortion associated with the sliding of plane layers over each other is the shear strain, within a deforming body. [2] This could be applied by elongation, shortening, or volume changes, or angular distortion. [3]
When an object is subjected to a force in a single direction (referred to as a uniaxial compression), the compressive stress is determined by dividing the applied force by the cross-sectional area of the object. [1] Consequently, compressive stress is expressed in units of force per unit area. Axial Stress