Search results
Results from the WOW.Com Content Network
The integration of a flux over an area gives the volumetric flow rate. The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or ...
With C v = 1.0 and 200 psia inlet pressure, the flow is 100 standard cubic feet per minute (scfm). The flow is proportional to the absolute inlet pressure, so the flow in scfm would equal the C v flow coefficient if the inlet pressure were reduced to 2 psia and the outlet were connected to a vacuum with less than 1 psi absolute pressure (1.0 ...
= 0.028 316 846 592 m 3 /s: cubic inch per minute in 3 /min ≡ 1 in 3 /min = 2.731 177 3 × 10 −7 m 3 /s cubic inch per second in 3 /s ≡ 1 in 3 /s = 1.638 7064 × 10 −5 m 3 /s: cubic metre per second (SI unit) m 3 /s ≡ 1 m 3 /s = 1 m 3 /s gallon (US fluid) per day GPD [citation needed] ≡ 1 gal/d = 4.381 263 63 8 × 10 −8 m 3 /s ...
Standard cubic centimeters per minute (SCCM) is a unit used to quantify the flow rate of a fluid. 1 SCCM is identical to 1 cm³ STP /min. Another expression of it would be Nml/min.
Standard cubic feet per minute (SCFM) is the molar flow rate of a gas expressed as a volumetric flow at a "standardized" temperature and pressure thus representing a fixed number of moles of gas regardless of composition and actual flow conditions.
cubic foot per day: cubic feet per day: m3/d: Cubic foot per second: cuft/h: cu ft/h: 28316846592e-12/3600: cubic foot per hour: cubic feet per hour: m3/h: Cubic foot per second: cuft/min: cu ft/min: 28316846592e-12/60: cubic foot per minute: cubic feet per minute: m3/min: Cubic foot per minute: cuft/s: cu ft/s: 28316846592e-12: cubic foot per ...
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
Where P is the power in airwatts, F is the rate per minute (denoted cu ft/min or CFM) and S is the suction capacity expressed as a pressure in inches of water. Some manufacturers choose to use the fraction 1 ⁄ 8.5 rather than the ASTM decimal, leading to a less than 0.25% variation in their calculations.