enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Oil pressure - Wikipedia

    en.wikipedia.org/wiki/Oil_pressure

    Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...

  3. Four-stroking - Wikipedia

    en.wikipedia.org/wiki/Four-stroking

    Four-stroking is a condition of two-stroke engines where combustion occurs every four strokes or more, rather than every two. Though normal in some instances at idle, extremely high engine speeds, and when letting off the throttle, such firing is uneven, noisy and may, in cases of malfunction, damage the engine if allowed to continue unabated.

  4. Four-stroke engine - Wikipedia

    en.wikipedia.org/wiki/Four-stroke_engine

    At this point the crankshaft has completed a full 360 degree revolution. While the piston is at T.D.C. (the end of the compression stroke) the compressed air-fuel mixture is ignited by a spark plug (in a gasoline engine) or by heat generated by high compression (diesel engines), forcefully returning the piston to B.D.C. This stroke produces ...

  5. Hydraulic tappet - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_tappet

    Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body. When the engine valve is closed (lifter in a neutral position), the lifter is free to fill with oil. As the camshaft lobe enters the lift phase of its travel, it compresses the lifter piston, and a check valve shuts the oil inlet ...

  6. Crankcase dilution - Wikipedia

    en.wikipedia.org/wiki/Crankcase_dilution

    Crankcase dilution occurs when the fuel oil from the engine gets into the lube oil of the engine. This can be caused by the walls being wetted due to the fuel condensing in the cylinder. If the engine is cold, or there is an excess amount of cooling around the cylinder, [ 1 ] the fuel oil will condense and have a higher chance to end up in the ...

  7. Diesel engine runaway - Wikipedia

    en.wikipedia.org/wiki/Diesel_engine_runaway

    Engines fitted with a decompressor can also be stopped by operating the decompressor, and in a vehicle with a manual transmission it is sometimes possible to stop the engine by engaging a high gear (i.e. 4th, 5th, 6th etc.), with foot brake and parking brake fully applied, and quickly letting out the clutch to slow the engine RPM to a stop ...

  8. Oil pump (internal combustion engine) - Wikipedia

    en.wikipedia.org/wiki/Oil_pump_(internal...

    Indications of low oil pressure may be that the warning light is on, a low pressure reading on the gauge, or clattering/clinking noises from the engine. Low oil pressure is a problem that must be addressed immediately to prevent serious damage. The leading cause of low oil pressure in an engine is wear on the engine's vital parts.

  9. Total-loss oiling system - Wikipedia

    en.wikipedia.org/wiki/Total-loss_oiling_system

    These engines were designed to have a total-loss lubrication system, with the motor oil held in a separate tank from the fuel in the vehicle, and not pre-mixed with it as with two-cycle engines, but mixed within the engine instead while running. Castor oil was often used because it lubricates well at the high temperatures found in air-cooled ...