Search results
Results from the WOW.Com Content Network
Engines using indirect injection generally have lower levels of knock than direct injection engines, due to the greater dispersal of oxygen in the combustion chamber and lower injection pressures providing a more complete mixing of fuel and air. Diesels actually do not suffer exactly the same "knock" as gasoline engines since the cause is known ...
The most common causes are accidents with grease guns, paint sprayers, and pressure washers, but working on diesel and gasoline engine fuel injection systems as well as pinhole leaks in pressurized hydraulic lines can also cause this injury. Additionally, there is at least one known case of deliberate self-injection with a grease gun. [2]
Although the IAC is supposed to last the vehicle's lifetime, various reasons may cause it to fail/malfunction prematurely. The most common failure mode is partial/complete jamming of the actuator (due to dirt/dust or even oil) where it cannot be smoothly controlled. The result is an engine that fails to maintain idle RPM and frequently stalls.
The engine can be drained as above and restarted. If a corrosive substance such as water has been in the engine long enough to cause rusting, more extensive repairs will be required. Amounts of water significant enough to cause hydrolock tend to upset the air/fuel mixture in gasoline engines.
Some fuel injection computers interpret "pumping" the throttle to indicate a flooded engine, and alter the fuel-air mixture accordingly. In a carbureted engine equipped with an accelerator pump (which advances fuel flow to match air ingestion under rapid throttle acceleration), "pumping" the throttle will force excess fuel into the engine ...
A blowoff valve (also called dump valve or compressor bypass valve) is a pressure release system present in most petrol turbocharged engines. Blowoff valves are used to reduce pressure in the intake system as the throttle is closed, thus preventing compressor surge .
Blow-by” gases are a mix of fuel oil and exhaust gases that push past the piston rings. Crankcase dilution is caused more when the lube oil is fresher. [3] Another cause of crankcase dilution is a slow or delayed injection cycle. [2] This causes the timing to be thrown off and the oil is most likely to enter the crankcase at this point.
Oil sludge may occur due to a variety of different factors. Some of the most common causes are: Defective crankcase ventilation system; Oil/coolant contamination; Neglecting oil changes; Low oil level; Poor engine design