Search results
Results from the WOW.Com Content Network
In data communications, flow control is the process of managing the rate of data transmission between two nodes to prevent a fast sender from overwhelming a slow receiver. Flow control should be distinguished from congestion control , which is used for controlling the flow of data when congestion has actually occurred. [ 1 ]
In the TS-ADC, this limitation is overcome by time-stretching the analog signal, which effectively slows down the signal in time prior to digitization. By doing so, the bandwidth (and carrier frequency) of the signal is compressed. Electronic ADCs that would have been too slow to digitize the original signal can now be used to capture and ...
When a communications link must span a larger distance than existing fiber-optic technology is capable of, the signal must be regenerated at intermediate points in the link by optical communications repeaters. Repeaters add substantial cost to a communication system, and so system designers attempt to minimize their use.
Stop (logic high (1)): the next one or two bits are always in the mark (logic high, i.e., 1) condition and called the stop bit(s). They signal to the receiver that the character is complete. Since the start bit is logic low (0) and the stop bit is logic high (1) there are always at least two guaranteed signal changes between characters.
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...
In computer networks, propagation delay is the amount of time it takes for the head of the signal to travel from the sender to the receiver. It can be computed as the ratio between the link length and the propagation speed over the specific medium. Propagation delay is equal to d / s where d is the distance and s is the wave propagation speed.
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires, optical fibers, wireless communication using radio spectrum, storage media and computer buses.
Limiting the speed of data sent by a data originator (a client computer or a server computer) is much more efficient than limiting the speed in an intermediate network device between client and server because while in the first case usually no network packets are lost, in the second case network packets can be lost / discarded whenever ingoing data speed overcomes the bandwidth limit or the ...