Search results
Results from the WOW.Com Content Network
The IDENTIFY DEVICE command queries a particular register on the IDE controller to establish the size of a drive. This register however can be changed using the SET MAX ADDRESS ATA command. If the value in the register is set to less than the actual hard drive size then effectively a host protected area is created.
IBM's first hard drive, the IBM 350, used a stack of fifty 24-inch platters and was of a size comparable to two large refrigerators. In 1962, IBM introduced its model 1311 disk, which used six 14-inch (nominal size) platters in a removable pack and was roughly the size of a washing machine. This became a standard platter size and drive form ...
If the actual size of the disk exceeds the maximum partition size representable using the legacy 32-bit LBA entries in the MBR partition table, the recorded size of this partition is clipped at the maximum, thereby ignoring the rest of the disk. This amounts to a maximum reported size of 2 TiB, assuming a disk with 512 bytes per sector (see 512e).
Logical block addressing (LBA) is a common scheme used for specifying the location of blocks of data stored on computer storage devices, generally secondary storage systems such as hard disk drives. LBA is a particularly simple linear addressing scheme; blocks are located by an integer index, with the first block being LBA 0, the second LBA 1 ...
The 11" model starts at $529, weighs 1.3 kg (2.9 pounds) and is 1.7 cm (0.67 inch) thick. The starting configuration is a quad-core Intel Pentium CPU and 500GB hard drive. [9] The $999 13-inch Yoga 2 weighs 1.6 kg (3.5 pounds) and is slightly thicker than the 11-inch model, with a 1,920x1,080 panel, 500GB hard drive, and backlit keyboard.
Click Location Services on the right. Turn ON Location Services , then turn ON Find My in the list of apps. Note: If you don’t see Find My, go to System Services in the list of apps, click ...
• Zoom in - Press Ctrl (CMD on a Mac) + the plus key (+) on your keyboard. • Zoom out - Press Ctrl (CMD on a Mac) + the minus key (-) on your keyboard. Zoomed too far? Press Ctrl (CMD on a Mac) + 0 to go back to the default size.
File size is a measure of how much data a computer file contains or how much storage space it is allocated. Typically, file size is expressed in units based on byte . A large value is often expressed with a metric prefix (as in megabyte and gigabyte ) or a binary prefix (as in mebibyte and gibibyte ).