enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   A 5-point can drill through 0.5 in (12.7 mm) of steel, for example. self-tapping machine screw: A self-tapping machine screw is similar to a machine screw, except the lower part of the shank is designed to cut threads as the screw is driven into an untapped hole.

4. Clip-on nut - Wikipedia

   en.wikipedia.org/wiki/Clip-on_nut

   An M6 spire clip or chimney U-nut for a bolt and a #8 u-nut for a self-tapping screw. A U-nut is very similar to a J-nut except that both legs are the same length. Because of this a retaining clip is usually formed on the leg without the threads. This helps keep the nut in place while not screwed down.

5. Fastener - Wikipedia

   en.wikipedia.org/wiki/Fastener

   B18.3 Socket Cap, Shoulder, Set Screws, and Hex Keys (Inch Series) B18.6.1 Wood Screws (Inch Series) B18.6.2 Slotted Head Cap Screws, Square Head Set Screws, And Slotted Headless Set Screws (Inch Series) B18.6.3 Machine Screws, Tapping Screws, and Metallic Drive Screws (Inch Series) B18.18 Quality Assurance For Fasteners

6. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...