enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   Column-to-foundation connection [1] Anchor bolts are used to connect structural and non-structural elements to concrete. [2] The connection can be made by a variety of different components: anchor bolts (also named fasteners), steel plates, or stiffeners. Anchor bolts transfer different types of load: tension forces and shear forces. [3]

3. Rebar - Wikipedia

   en.wikipedia.org/wiki/Rebar

   The diameter of the equivalent large format round shape is rounded to the nearest 1 ⁄ 8 inch to provide the bar size. For example, #9 bar has a cross section of 1.00 square inch (6.5 cm 2), and therefore a diameter of 1.128 inches (28.7 mm). #10, #11, #14, and #18 sizes correspond to 1 1 ⁄ 8 inch, 1 1 ⁄ 4, 1 1 ⁄ 2, and 2-inch square ...

4. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

5. Anchor channel - Wikipedia

   en.wikipedia.org/wiki/Anchor_channel

   Anchor channels, invented by Anders Jordahl in 1913, are steel channels cast flush in reinforced concrete elements to allow the installation of channel bolts for the fastening of components. Anchor channels consist of steel C-shaped channels and anchors (mostly headed studs ) which are connected to the channel by welding or riveting/forging.

6. Precast concrete lifting anchor system - Wikipedia

   en.wikipedia.org/wiki/Precast_concrete_lifting...

   F/n = 23 kN per anchor during initial lift (n = 2 lifting anchors) Transport loads in the yard and on-site Suction due to casting bed adhesion is not considered, as the calculation takes into account the lifting device dynamic coefficient. S = (W x Ksl x Kd) / n = (64.8 x 1.16 x 1.2) / 2 = 45.1 kN load resistance required per anchor

7. News, Politics, Sports, Mail & Latest Headlines - AOL.com

   firefox-startpage.aol.com

   Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.