Search results
Results from the WOW.Com Content Network
Maximum distortion energy theory, also known as maximum distortion energy theory of failure or von Mises–Hencky theory. This theory postulates that failure will occur when the distortion energy per unit volume due to the applied stresses in a part equals the distortion energy per unit volume at the yield point in uniaxial testing.
By its basic definition the uniaxial stress is given by: ´ =, where F is load applied [N] and A is area [m 2]. As stated, the area of the specimen varies on compression. In reality therefore the area is some function of the applied load i.e. A = f (F). Indeed, stress is defined as the force divided by the area at the start of the experiment.
Limit load is the maximum load that a structure can safely carry. It's the load at which the structure is in a state of incipient plastic collapse. As the load on the structure increases, the displacements increases linearly in the elastic range until the load attains the yield value.
For ductile materials, the yield strength is typically distinct from the ultimate tensile strength, which is the load-bearing capacity for a given material. The ratio of yield strength to ultimate tensile strength is an important parameter for applications such steel for pipelines , and has been found to be proportional to the strain hardening ...
This formula was derived in 1744 by the Swiss mathematician Leonhard Euler. [2] The column will remain straight for loads less than the critical load. The critical load is the greatest load that will not cause lateral deflection (buckling). For loads greater than the critical load, the column will deflect laterally.
Strength depends upon material properties. The strength of a material depends on its capacity to withstand axial stress, shear stress, bending, and torsion.The strength of a material is measured in force per unit area (newtons per square millimetre or N/mm², or the equivalent megapascals or MPa in the SI system and often pounds per square inch psi in the United States Customary Units system).
Mechanical load is the physical stress on a mechanical system or component [1] leading to strain. Loads can be static or dynamic. Some loads are specified as part of the design criteria of a mechanical system. Depending on the usage, some mechanical loads can be measured by an appropriate test method in a laboratory or in the field.
Limit load can refer to: Limit load (aeronautics) , the maximum load factor during flight Limit load (physics) , maximum load that a structure can safely carry