Ads
related to: online sectional chart
Search results
Results from the WOW.Com Content Network
The first sectional chart was published in 1930; in 1937 the full series of the lower 48 states was completed. These early sectional charts were smaller (most covered two degrees of latitude and six of longitude) with the map on one side; after 1950 the legend and index to adjoining charts was on the reverse.
A sectional chart is a two-sided chart created from a Lambert Conformal Conic Projection [1] with two defined standard parallels. The scale is 1:500,000, with a contour interval of 500 feet. The size of each sectional is designed to be "arm's width" when completely unfolded.
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
MEF's of 4700 and 3300 feet are shown on this excerpt from the FAA's Los Angeles sectional aeronautical chart. Maximum elevation figure (MEF) is a type of visual flight rule (VFR) information that indicates the elevation of the highest geographical feature within a GEOREF quadrangle area.
FAA-Terminal Area Chart Baltimore-Washington from 2011. Like the VFR sectional charts that they complement, terminal area charts depict topographic features and other information of interest to aviators flying visually, including major landmarks, terrain elevations, visual navigation routes, ground-based navigation aids, airports, rivers, cities, and airspace boundaries.
Victor airways are depicted as black solid lines on IFR Low-Altitude Enroute charts and as thick faded blue lines on VFR Terminal and Sectional Area charts. They are identified by a number, similar to an interstate highway (for example, a pilot could say that he/she is "flying Victor Eight").
Pilots use aeronautical charts based on LCC because a straight line drawn on a Lambert conformal conic projection approximates a great-circle route between endpoints for typical flight distances. The US systems of VFR (visual flight rules) sectional charts and terminal area charts are drafted on the LCC with standard parallels at 33°N and 45 ...
These charts are similar to sectional charts, and the symbols are the same. However, there is less detail at the smaller scale, so it is seldom used for visual flight rules flight at slower speeds or for local flights. WACs show topographic information, airports and radio navigational aids. They are useful for strategic flight planning, where a ...
Ads
related to: online sectional chart