enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Copper cable certification - Wikipedia

    en.wikipedia.org/wiki/Copper_cable_certification

    The greater the variation in impedance, the greater the return loss reading. If three pairs of wire pass by a substantial amount, but the fourth pair barely passes, it usually is an indication of a bad crimp or bad connection at the RJ45 plug. Return loss is usually not significant in the loss of a signal, but rather signal jitter.

  3. Decibel - Wikipedia

    en.wikipedia.org/wiki/Decibel

    The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...

  4. Dynamic range - Wikipedia

    en.wikipedia.org/wiki/Dynamic_range

    Multiple noise processes determine the noise floor of a system. Noise can be picked up from microphone self-noise, preamp noise, wiring and interconnection noise, media noise, etc. Early 78 rpm phonograph discs had a dynamic range of up to 40 dB, [24] soon reduced to 30 dB and worse due to wear from repeated play. Vinyl microgroove phonograph ...

  5. Electrical wiring - Wikipedia

    en.wikipedia.org/wiki/Electrical_wiring

    The first rubber-insulated cables for US building wiring were introduced in 1922 with US patent 1458803, Burley, Harry & Rooney, Henry, "Insulated electric wire", issued 1923-06-12, assigned to Boston Insulated Wire and Cable . These were two or more solid copper electrical wires with rubber insulation, plus woven cotton cloth over each ...

  6. Signal integrity - Wikipedia

    en.wikipedia.org/wiki/Signal_integrity

    Noise may cause a signal to assume the wrong value. This is particularly critical when the signal is about to be latched (or sampled), for a wrong value could be loaded into a storage element, causing logic failure. Noise may delay the settling of the signal to the correct value. This is often called noise-on-delay.

  7. Signal strength in telecommunications - Wikipedia

    en.wikipedia.org/wiki/Signal_strength_in...

    High-powered transmissions, such as those used in broadcasting, are expressed in dB-millivolts per metre (dBmV/m). For very low-power systems, such as mobile phones, signal strength is usually expressed in dB-microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt .

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Coaxial cable - Wikipedia

    en.wikipedia.org/wiki/Coaxial_cable

    Coaxial cable, or coax (pronounced / ˈ k oʊ. æ k s /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket.