Search results
Results from the WOW.Com Content Network
Microwave Doppler frequency shift produced by reflector motion falls into the audible sound range for human beings (20–20 000 Hz), which is used for target classification in addition to the kinds of conventional radar display used for that purpose, like A-scope, B-scope, C-scope, and RHI indicator. The human ear may be able to tell the ...
Pulse-Doppler signal processing separates reflected signals into a number of frequency filters. There is a separate set of filters for each ambiguous range. The I and Q samples described above are used to begin the filtering process. These samples are organized into the m × n matrix of time domain samples shown in the top half of the diagram.
The range and velocity of a target are detected through pulse delay ranging and the Doppler effect (pulse-Doppler), or through the frequency modulation (FM) ranging and range differentiation. The range resolution is limited by the instantaneous signal bandwidth of the radar sensor in both pulse-Doppler and frequency modulated continuous wave ...
For premium support please call: 800-290-4726 more ways to reach us
If however, the PRF was doubled to 15 kHz, then the ambiguous range is reduced to 10 km and targets beyond this range would only appear on the display after the transmitter has emitted another pulse. A target at 12 km would appear to be 2 km away, although the strength of the echo might be much lower than that from a genuine target at 2 km.
Other difficulties arise when the interference covariance matrix is ill-conditioned, making the inversion numerically unstable. [5] In general, this adaptive filtering must be performed for each of the unambiguous range bins in the system, for each target of interest (angle-Doppler coordinates), making for a massive computational burden. [4]
Range ambiguity resolution is a technique used with medium pulse-repetition frequency (PRF) radar to obtain range information for distances that exceed the distance between transmit pulses. This signal processing technique is required with pulse-Doppler radar .
Measurement of a target's RCS is performed at a radar reflectivity range or scattering range. [citation needed] The first type of range is an outdoor range where the target is positioned on a specially shaped low RCS pylon some distance down-range from the transmitters. Such a range eliminates the need for placing radar absorbers behind the ...