Search results
Results from the WOW.Com Content Network
Media Redundancy Protocol (MRP) is a data network protocol standardized by the International Electrotechnical Commission as IEC 62439-2. It allows rings of Ethernet switches to overcome any single failure with recovery time much faster than achievable with Spanning Tree Protocol. [1] It is suitable to most industrial Ethernet applications
In computer networking, link aggregation is the combining (aggregating) of multiple network connections in parallel by any of several methods. Link aggregation increases total throughput beyond what a single connection could sustain, and provides redundancy where all but one of the physical links may fail without losing connectivity.
The link layer includes the protocols that define communication between local (on-link) network nodes which fulfill the purpose of maintaining link states between the local nodes, such as the local network topology, and that usually use protocols that are based on the framing of packets specific to the link types.
Distributed split multi-link trunking (DSMLT) or Distributed SMLT is a computer networking technology developed at Nortel to enhance the Split Multi-Link Trunking protocol. DSMLT allows the ports in a trunk to span multiple units of a stack of switches or to span multiple cards in a chassis, preventing network outages when one switch in a stack ...
A fully connected network, complete topology, or full mesh topology is a network topology in which there is a direct link between all pairs of nodes. In a fully connected network with n nodes, there are () direct links. Networks designed with this topology are usually very expensive to set up, but provide a high degree of reliability due to the ...
The spanning-tree algorithm then blocks forwarding on redundant links by setting up one preferred link between switches in the LAN. This preferred link is used for all Ethernet frames unless it fails, in which case a non-preferred redundant link is enabled. When implemented in a network, STP designates one layer-2 switch as root bridge. All ...
With mesh networking, access points are connected wirelessly and exchange data frames with each other to forward to/from a gateway point. Since a mesh requires no costly cable constructions for its backhaul network, it reduces total investment cost. Mesh technology’s capabilities can boost extending coverage of service areas easily and flexibly.
The internet layer is a group of internetworking methods, protocols, and specifications in the Internet protocol suite that are used to transport network packets from the originating host across network boundaries; if necessary, to the destination host specified by an IP address.