Ads
related to: proof strength of bolt diameter calculator mm
Search results
Results from the WOW.Com Content Network
6. (Now withdrawn) Nuts with specified proof load values – Fine pitch thread [7] 7. Torsional test and minimum torques for bolts and screws with nominal diameters 1 mm to 10 mm [8] With exception to part 7, which defines test standards, the parts of this standard define properties for fasteners made of carbon steel and alloy steel.
It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1] The equivalent metric standard is ASTM A325M, which is titled Standard Specification for Structural Bolts, Steel, Heat Treated 830 MPa Minimum Tensile Strength. It defines mechanical properties for sizes M12–36. [2]
Nominal thread diameter size range [mm] Proof strength [MPa] Yield strength (min) [MPa] Tensile strength (min) [MPa] Core hardness [Rockwell] Class 4.6 Low or medium carbon steel: 5–100: 225: 240: 400: B67–95 Class 4.8 Low or medium carbon steel; fully or partially annealed: 1.6–16: 310: 340: 420: B71–95 Class 5.8 Low or medium carbon ...
The preferred bolt preload for structural applications should be at least 75% of the fastener's proof load [7] for the higher strength fasteners and as high as 90% of the proof load for permanent fasteners. To achieve the benefits of the preloading, the clamping force must be higher than the joint separation load.
This standard defines the properties for fasteners up to 4 inches in diameter. They are not to be used in applications where they are tensioned to more than 50% of their tensile strength. In those applications structural heavy hex bolts are to be used, as defined by ASTM A490, even though they have the same strength. [1] [2]
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
Minimum proof testing pressures are specified by the owner of the cartridge specification, such as C.I.P. or SAAMI for most commercial cartridges or NATO EPVAT testing for appropriate military cartridges. An example proofing round for the .50 BMG (12.7 × 99 mm) is the "cartridge, caliber .50, test, high pressure, M1". This uses the standard ...
Ads
related to: proof strength of bolt diameter calculator mm