enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Minimum obstacle clearance altitude - Wikipedia

    en.wikipedia.org/wiki/Minimum_obstacle_clearance...

    The MOCA seen on the NACO en route chart, may have been computed by adding the required obstacle clearance (ROC) to the controlling obstacle in the primary area or computed by using a TERPS chart if the controlling obstacle is located in the secondary area. This figure is then rounded to the nearest 100 foot increment, i.e. 2,049 feet becomes ...

  3. Minimum crossing altitude - Wikipedia

    en.wikipedia.org/wiki/Minimum_crossing_altitude

    In this case, a segment of an airway ending at fix ABC has a MEA of 5200 feet MSL, and the minimum obstacle clearance altitude (MOCA) required to clear an obstacle six nautical miles from the fix within the next segment is 6620 feet MSL. The total increase in altitude from 5200 feet to 6620 feet over that distance is 1420 feet.

  4. Lowest safe altitude - Wikipedia

    en.wikipedia.org/wiki/Lowest_safe_altitude

    The AMA is the lowest off-airway altitude to be used under instrument meteorological conditions (IMC) that will provide a minimum vertical clearance of 1,000 feet , or in designated mountainous terrain 2,000 feet above all obstacles located in the area specified, rounded up to the nearest 100 foot increment.

  5. Minimum en route altitude - Wikipedia

    en.wikipedia.org/wiki/Minimum_en_route_altitude

    Minimum en route altitude (MEA), [1] alternately spelled as Minimum enroute altitude, [2] is the lowest published altitude between radio navigation fixes that assures acceptable navigational signal coverage (see MRA) and meets obstacle clearance requirements (see MOCA) between those fixes.

  6. Instrument flight rules - Wikipedia

    en.wikipedia.org/wiki/Instrument_flight_rules

    A clearance always specifies a clearance limit, which is the farthest the aircraft can fly without a new clearance. In addition, a clearance typically provides a heading or route to follow, altitude, and communication parameters, such as frequencies and transponder codes. In uncontrolled airspace, ATC clearances are unavailable.

  7. CRAFT (aviation) - Wikipedia

    en.wikipedia.org/wiki/CRAFT_(aviation)

    The initial altitude is sometimes stated on the charts. If not, it will be given by the air traffic controller. The departure frequency is given to the pilot when ATC hands the aircraft over to the next sector. A typical IFR clearance would be: OOABC, cleared to Ostend via the DENUT 7C departure, climb flight level six zero, squawk four six ...

  8. Military operations area - Wikipedia

    en.wikipedia.org/wiki/Military_operations_area

    Whenever an MOA is active, nonparticipating IFR traffic may be cleared through the area provided ATC can ensure IFR separation; otherwise, ATC will reroute or restrict nonparticipating IFR traffic. Although MOA's do not restrict VFR operations, pilots operating under VFR should exercise extreme caution while flying within, near, or below an ...

  9. Minimum reception altitude - Wikipedia

    en.wikipedia.org/wiki/Minimum_reception_altitude

    An MRA is determined by FAA flight inspection traversing an entire route of flight to establish the minimum altitude the navigation signal can be received for the route (which, along with obstacle clearance, defines the Minimum Enroute Altitude - MEA) and for off-course NAVAID facilities that determine a fix.