Search results
Results from the WOW.Com Content Network
Permanent start-up, flush and bypass lines; Pipelines and flowlines; Blinds and spectacle blinds; Insulation and heat tracing; Process control instrumentation and designation (names, numbers, unique tag identifiers), including: Valves and their types and identifications (e.g. isolation, shutoff, relief and safety valves, valve interlocks)
A blowoff valve is designed to release pressure in the intake system when the throttle is closed. A "recirculating" type blowoff valve releases the pressurised air back into the non-pressurized section of the intake (i.e. upstream of the turbocharger), while an "atmospheric venting" type blowoff valve dumps the air directly into the atmosphere.
A pressure washer is used to remove old paint from a boat. Patio flagstones being pressure washed using a rotary nozzle. Pressure washing or power washing is the use of high-pressure water spray to remove loose paint, mold, grime, dust, mud, and dirt from surfaces and objects such as buildings, vehicles and concrete surfaces.
The sheet has a solid end and a flow-through end; sliding it from one position to the other opens or stops the flow. Also called sliding blind valve; Outflow valve: regulates flow and pressure, part of cabin pressurization; Pilot valve: regulates flow or pressure to other valves; Petcock, a small shut-off valve
A relief valve DN25 on cooling water pipe from heat exchanger Schematic diagram of a conventional spring-loaded pressure relief valve. A relief valve or pressure relief valve (PRV) is a type of safety valve used to control or limit the pressure in a system; excessive pressure might otherwise build up and create a process upset, instrument or equipment failure, explosion, or fire.
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure, temperature, and liquid level.
A back-pressure regulator, back-pressure valve, pressure sustaining valve or pressure sustaining regulator is a control valve that maintains the set pressure at its inlet side by opening to allow flow when the inlet pressure exceeds the set value.
The EDS is also intended to automatically trigger the deadman switch, which closes the BOP, kill and choke valves. The EDS may be a subsystem of the BOP stack's control pods or separate. [citation needed] Pumps on the rig normally deliver pressure to the blowout preventer stack through hydraulic lines.