Search results
Results from the WOW.Com Content Network
The 18, 15, 11, 6, 3, and 2 gauge shells are the rarest of all; [10] owners of these types of rare shotguns will usually have their ammunition custom loaded by a specialist in rare and custom bores. The 14 gauge has not been loaded in the United States since the early 20th century, although the 2 + 9 ⁄ 16-inch (65 mm) hull is still made in ...
It is not to be confused with a true unitless ratio. A 1:5 architectural scale (inches to feet) would be a 1:60 unitless scale (inches to inches) since there are 60 inches in 5 feet. Typical scales used in the United States are: [1] full scale, with inches, divided into sixteenths of an inch
Derived from the scale of 1 inch equals 10 feet.TT model railroad scale. Used in AD&D Battlesystem Skirmishes rules. Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm Used for some model ships, aircraft and diecast cars. 1:108: 2.822 mm
Originally in 1945, the divisions were based on the ring inside diameter in steps of 1 ⁄ 64 inch (0.40 mm). [6] However, in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals 1.25 mm of circumferential length.
1:18 scale is a traditional scale (ratio) for models and miniatures, in which 18 units (such as inches or centimeters) on the original is represented by one unit on the model. Depending on application, the scale is also called two third inch scale since 1 foot is represented by 2/3 of an inch. [1]
1:32 scale is a traditional scale for models and miniatures, in which one unit (such as an inch or a centimeter) on the model represents 32 units on the actual object. It is also known as "three-eighths scale", since 3 ⁄ 8 inch represents a foot. A 6 ft (183 cm) tall person is modeled as 2 + 1 ⁄ 4 in (57 mm) tall in 1:32 scale.
By definition, 36 AWG is 0.005 inches in diameter, and 0000 AWG is 0.46 inches in diameter. The ratio of these diameters is 1:92, and there are 40 gauge sizes from 36 to 0000, or 39 steps. Because each successive gauge number increases cross sectional area by a constant multiple, diameters vary geometrically.
The machine's gauge is expressed by the number of needles needed to achieve that gauge. B – Used for hand, mechanical, or modern Electronic Flat Machines (Stoll, Shima, Protti, etc.), where gauge is measured in 1-inch (2.5 cm) increments. The machine's gauge is again measured by the number of needles required to achieve that number.