enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Furniture screw - Wikipedia

   en.wikipedia.org/wiki/Furniture_screw

   Insert nut, a type of en type of threaded insert for wood; Sex bolt, a type of nut with a low shoulder (flange) to provide resistance with little protrusion; T-nut, a nut that can be knocked into the back of a wood plate to provide a screw mounting hole; Wood hanger screw, a screw with machine threads in one end, and wood screw threads in the other

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

4. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   The Whitworth thread was the world's first national screw thread standard, [1] devised and specified by Joseph Whitworth in 1841. Until then, the only standardization was what little had been done by individual people and companies, with some companies' in-house standards spreading a bit within their industries.

5. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Where a fastener forms its own thread in the component being fastened, it is called a screw. [3] This is most obviously so when the thread is tapered (i.e. traditional wood screws), precluding the use of a nut, [3] or when a sheet metal screw or other thread-forming screw is used. A screw must always be turned to assemble the joint.

6. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A typical lag screw can range in diameter from 4 to 20 mm or #10 to 1.25 in (4.83 to 31.75 mm), and lengths from 16 to 200 mm or 1 ⁄ 4 to 6 in (6.35 to 152.40 mm) or longer, with the coarse threads of a wood-screw or sheet-metal-screw threadform (but larger).

7. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   Unified Inch Screw Threads (UN and UNR Thread Form) V Thread Form: 1 ⁄ 4 ″-20 UNC #4-40 UNC ASME B1.5-1997 (R2014) Acme Screw Threads: Trapezoidal Thread Form: Tr 60×9 ANSI/ASME B1.9-1973 (R2017) Buttress Inch Screw Threads: Breech-Lock Thread Form: ASME B1.10M-2004 (R2014) Unified Miniature Screw Threads: V Thread Form: 0.60 UNM ANSI/ASME ...