enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rating plate - Wikipedia

   en.wikipedia.org/wiki/Rating_plate

   A typical electrical generator rating plate contains the following parameters: [4] power rating is specified in terms of apparent power (KVA or MVA), since the exact power factor will be determined by the external factors; [5] power factor (PF) is the nominal power factor for other ratings; usually PF = 0.8; [5]

3. Load bank - Wikipedia

   en.wikipedia.org/wiki/Load_bank

   A resistive load bank, the most common type, provides equivalent loading for both generators and prime movers. That is, for each kilowatt (or horsepower) of load applied to the generator by the load bank, an equal amount of load is applied to the prime mover by the generator. A resistive load bank, therefore, removes energy from the complete ...

4. Diesel generator - Wikipedia

   en.wikipedia.org/wiki/Diesel_generator

   Set sizes range from 8 to 30-kW (also 8 to 30-kVA single phase) for homes, small shops, and offices, with the larger industrial generators from 8-kW (11 kVA) up to 2,000-kW (2,500-kVA three phase) used for office complexes, factories, and other industrial facilities. A 2,000-kW set can be housed in a 40 ft (12 m) ISO container with a fuel tank ...

5. Short circuit ratio (electrical grid) - Wikipedia

   en.wikipedia.org/wiki/Short_circuit_ratio...

   In an electrical grid, the short circuit ratio (or SCR) is the ratio of: the short circuit apparent power (SCMVA) in the case of a line-line-line-ground (3LG) fault at the location in the grid where some generator is connected, to: the power rating of the generator itself (GMW).

6. Volt-ampere - Wikipedia

   en.wikipedia.org/wiki/Volt-ampere

   Some devices, including uninterruptible power supplies (UPSs), have ratings both for maximum volt-amperes and maximum watts. A common prefixed derived unit is "kilovolt-ampere" (symbol kVA). The VA rating is limited by the maximum permissible current, and the watt rating by the power-handling capacity of the device.

7. Power factor - Wikipedia

   en.wikipedia.org/wiki/Power_factor

   In electrical engineering, the power factor of an AC power system is defined as the ratio of the real power absorbed by the load to the apparent power flowing in the circuit. . Real power is the average of the instantaneous product of voltage and current and represents the capacity of the electricity for performing