enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Quarter round - Wikipedia

   en.wikipedia.org/wiki/Quarter_round

   Quarter round molding at the edge of a parquet floor. A quarter round is a convex molding whose cross section is a quarter circle. It is one form of ovolo. A variation is a base shoe, a quarter of an ellipse. [1] Most quarter round is of small gauge and relatively flexible.

3. Molding (decorative) - Wikipedia

   en.wikipedia.org/wiki/Molding_(decorative)

   Ovolo: Simple, convex quarter-round moulding that can also be enriched with the egg-and-dart or other pattern; Neck moulding; Panel mould: A moulding that is flat on the back and profiled on the face. It is applied directly on a flat surface like a wall or flush door in squares or rectangles to simulate a panel.

4. Baseboard - Wikipedia

   en.wikipedia.org/wiki/Baseboard

   A baseboard differs from a wainscot; a wainscot typically covers from the floor to around 1-1.5 metres (3' to 5') high (waist or chest height), whereas a baseboard is typically under 0.2 metres (8") high (ankle height). Plastic baseboard comes in various plastic compounds, the most common of which is UPVC.

5. Ovolo - Wikipedia

   en.wikipedia.org/wiki/Ovolo

   The quarter-round cross-sectional profile of the fundamental design element, the ovolo, in an unadorned molding, showing also with its resulting shadow pattern. Ovolo is an Italian word that means "little egg". [1] The ovolo or echinus is a convex decorative molding profile used in architectural ornamentation. Its profile is a quarter to a half ...

6. Multi-material injection molding - Wikipedia

   en.wikipedia.org/wiki/Multi-material_injection...

   Multi-material injection molding (MMM) is the process of molding two or more different materials into one plastic part at one time. [1] As is the case in traditional injection molding, multi material injection molding uses materials that are at or near their melting point so that the semi-liquidous material can fill voids and cavities within a pre-machined mold, thus taking on the desired ...

7. Cube mold technology - Wikipedia

   en.wikipedia.org/wiki/Cube_mold_technology

   Cube mold technology (also known as Rotating cube mold technology or Stack-turning molding) is a molding process for the manufacture of plastics components. This molding process allows to manufacture circular parts. This technology was introduced by Foboha (a business unit of Barnes Group) and Arburg. [1] [2] [3]