Search results
Results from the WOW.Com Content Network
In 1950, Franklin introduced the first electric motor that was fully submersible. The new pump motors were quiet, resistant to freezing, smaller, easy to install, and had a high pumping capacity. The new motors could recover water from much deeper in the earth, making it possible for the first time to develop areas with low water tables.
Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]
A 0.75 HP bore-well submersible pump which had been used to pump groundwater One style of submersible pump for industrial use. Outlet pipe and electrical cable not connected. A submersible pump (or electric submersible pump (ESP) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in ...
Submersible pumps are mounted on two vertical guide rails and seal onto a permanently fixed "duckfoot", which forms both a mount and also a vertical bend for the discharge pipe. For maintenance or replacement, submersible pumps are raised by a chain off of the duckfoot and up the two guide rails to the maintenance (normally ground) level.
Grinder pumps can be installed in the basement or in the yard. If installed in the yard, the holding tank must be buried deep enough that the pump and sewage pipes are below the frost line. A grinder pump is different from a sump pump or effluent pump. There are two types of grinder pumps, semi-positive displacement (SPD) and centrifugal.
Magnetically coupled pumps, or magnetic drive pumps, vary from the traditional pumping style, as the motor is coupled to the pump by magnetic means rather than by a direct mechanical shaft. The pump works via a drive magnet, 'driving' the pump rotor, which is magnetically coupled to the primary shaft driven by the motor. [8]
Pleuger Industries was founded in 1929 by Friedrich Wilhelm Pleuger, when he invented glandless motor as a replacement to the borehole shaft and piston pumps. [12] [13] Since water was used to lubricate and cool the bearings of the wet rotor motor, the patent was regarded particularly ecologically benign and effective at the time.
A diagram of a pumpjack. A pumpjack is the overground drive for a reciprocating piston pump in an oil well. [1]It is used to mechanically lift liquid out of the well if there is not enough bottom hole pressure for the liquid to flow all the way to the surface.