Ad
related to: what is i2c used for
Search results
Results from the WOW.Com Content Network
In AmigaOS one can use the i2c.resource component [25] for AmigaOS 4.x and MorphOS 3.x or the shared library i2c.library by Wilhelm Noeker for older systems. Arduino developers can use the "Wire" library. CircuitPython and MicroPython developers can use the busio.I2C or machine.I2C classes respectively.
The Power Management Bus (PMBus) is a variant of the System Management Bus (SMBus) which is targeted at digital management of power supplies.Like SMBus, it is a relatively slow speed two wire communications protocol based on I²C.
SMBus is used as an interconnect in several platform management standards including: Alert Standard Format (ASF), Desktop and mobile Architecture for System Hardware (DASH), Intelligent Platform Management Interface (IPMI). SMBus is used to access DRAM configuration information as part of serial presence detect (SPD). SMBus has grown into a ...
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
This page was last edited on 19 January 2006, at 05:53 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
The Wishbone Bus is used by many designs in the OpenCores project. Wishbone is intended as a "logic bus". It does not specify electrical information or the bus topology. Instead, the specification is written in terms of "signals", clock cycles, and high and low levels. This ambiguity is intentional.
All of the terms in this category precede a common three-letter noun (hint: the word typically refers to a small container that's used for drinking). Related: 300 Trivia Questions and Answers to ...
I²C Extended (10-bit) Addresses. All devices on an I3C bus are addressed by a 7-bit address. Native I3C devices have a unique 48-bit address which is used only during dynamic address assignments. If clock stretching is needed, a "I3C Hub" can be used to bridge between the I3C network and the I²C target device. [17]
Ad
related to: what is i2c used for