Search results
Results from the WOW.Com Content Network
At light to medium throttle, the stator blades were at 32°, providing a torque multiplication of 1.8:1 and a converter stall speed of approximately 1800 rpm. At ⅔ to full throttle, the blades switched to the 51° high position, giving torque multiplication of 2.45:1 and a stall speed of approximately 2300 rpm.
At stall, the torque converter can produce maximum torque multiplication if sufficient input power is applied (the resulting multiplication is called the stall ratio). The stall phase actually lasts for a brief period when the load (e.g., vehicle) initially starts to move, as there will be a very large difference between pump and turbine speed.
Stall torque is the torque produced by a mechanical device whose output rotational speed is zero. It may also mean the torque load that causes the output rotational speed of a device to become zero, i.e., to cause stalling. Electric motors, steam engines and hydrodynamic transmissions are all capable of developing torque when stalled.
An important characteristic of a fluid coupling is its stall speed. The stall speed is defined as the highest speed at which the pump can turn when the output turbine is locked and full input torque (at the stall speed) is applied. Under stall conditions all of the engine's power at that speed would be dissipated in the fluid coupling as heat ...
The basis of the Turboglide's unique abilities was its five-element torque converter.Most automatic transmissions have a three-element torque converter, consisting of an impeller (an engine-driven pump); a turbine that rotates with the flywheel; a transmission-driven turbine that receives the energy of the oil propelled by the impeller, and a stator that redirects the recirculating oil so that ...
On a Torque-rotor speed diagram, this looks as follows: where the black line represents the initial section of the operating strategy for a variable speed stall-regulated wind turbine. Ideally, we would want to stay on the maximum efficiency curve until rated power is hit. However, as the rotor speed increases, the noise levels increase.
V S: Stall speed: the speed at which the airplane exhibits those qualities accepted as defining the stall. [26]: 8 V S0: The stall speed or minimum steady flight speed in landing configuration. [27] The zero-thrust stall speed at the most extended landing flap setting. [26]: 8 V S1: The stall speed or minimum steady flight speed obtained in a ...
Stall speed or minimum steady flight speed for which the aircraft is still controllable in a specific configuration. [7] [8] V S R: Reference stall speed. [7] V S R 0: Reference stall speed in landing configuration. [7] V S R 1: Reference stall speed in a specific configuration. [7] V SW: Speed at which the stall warning will occur. [7] V TOSS