Search results
Results from the WOW.Com Content Network
Slot screw drives have a single horizontal indentation (the slot) in the fastener head and is driven by a "common blade" or flat-bladed screwdriver.This form was the first type of screw drive to be developed, and, for centuries, it was the simplest and cheapest to make because it can just be sawed or filed.
A hex shank can be grasped by a 3-jaw drill chuck or held in a chuck specifically for hex shanks. Quarter-inch hex shanks are common for machine screwdriver bits and have spread from that application to be used for drill bits that are compatible with screwdriver machinery. Zero manufacturing if the drill bit is made from hex bar stock
In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...
While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...
A screw gun looks like a drill, but has a "nose" instead of a chuck. The nose holds an interchangeable 1 ⁄ 4-inch (6.4 mm) shank bit, commonly known as a tip. The most common types of tips are 1 inch (25 mm) No. 2 Phillips, T25 Torx, and flatheads. The nose on either type of screw gun can be adjusted to countersink screws to the desired depth ...
A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...
Coolant may be introduced via holes through the drill shank, which is common when using a gun drill. When cutting aluminum in particular, cutting fluid helps ensure a smooth and accurate hole while preventing the metal from grabbing the drill bit in the process of drilling the hole. When cutting brass, and other soft metals that can grab the ...
Such an appropriately sized drill is called a tap drill for that size of thread, because it is a correct drill to be followed by the tap. Many thread sizes have several possible tap drills, because they yield threads of varying thread depth between 50% and 100%.