Search results
Results from the WOW.Com Content Network
A DOWS system installed in a borehole will receive the fluids from an oil-producing zone in an oil reservoir and separate the mixture into a stream that is mostly water and a stream that is primarily crude oil and natural gas and direct the streams to different destinations. After the separation in the borehole, DOWS systems pump the petroleum ...
In a centrifugal oil and water separator, the force of gravity is one-thousand [citation needed] times greater that of the coalescing plate pack separator or the petrol interceptor, so the separation is much greater. Not only is the force of separation greater, but there are fewer working parts so maintenance is much easier and cheaper. [5]
Downhole oil–water separation (DOWS) technology is an emerging technology that separates oil and gas from produced water at the bottom of the well, and re-injects most of the produced water into another formation which is usually deeper than the producing formation, while the oil and gas rich stream is pumped to the surface.
A spreader plate that disperses the oil into small streams or rivulets increases the effectiveness of the heated-water bath. Upward flow of the oil through the water bath affords slight agitation, which is helpful in coalescing and separating entrained gas from the oil. A heated-water bath is probably the most effective method of removing foam ...
The API separator is a gravity separation device designed using Stokes' law principles that define the rise velocity of oil droplets based on their density, size and water properties. The design of the separator is based on the specific gravity difference between the oil and the wastewater because that difference is much smaller than the ...
Oil filtration systems generally use a multistage filtration with coarse and fine filters. [2] Centrifugation is separation of oil and water, or oil and solid particles by centrifugal forces. Vacuum treatment degasses and dehydrates industrial oil. This method is well suited for removing dispersed and dissolved water, as well as dissolved gases ...
Oil and water flow is by a countercurrent, gravity driven drainage into the lower well bore. The condensed water and crude oil or bitumen is recovered to the surface by pumps such as progressive cavity pumps that work well for moving high-viscosity fluids with suspended solids.
Three phase separation into oil, vapour and produced water takes place. The flowrates of these phases are accurately measured as the fluids flow to lower pressure points in the oil train. The flowrates determine the performance of the well in terms of the maximum flow of the well, the gas-oil ratio, and the water cut of the fluids.