Search results
Results from the WOW.Com Content Network
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication , where several bits are sent as a whole, on a link with several parallel channels.
Parallel versus serial communication. In data transmission, parallel communication is a method of conveying multiple binary digits simultaneously using multiple conductors. This contrasts with serial communication, which conveys only a single bit at a time; this distinction is one way of characterizing a communications link.
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
Practically all parallel communications protocols use synchronous transmission. For example, in a computer, address information is transmitted synchronously—the address bits over the address bus, and the read or write strobes of the control bus. Single-wire synchronous signalling
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires , optical fibers , wireless communication using radio spectrum , storage media and computer buses .
A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1] This is in contrast to a parallel port , which communicates multiple bits simultaneously in parallel .
USARTs in synchronous mode transmits data in frames. In synchronous operation, characters must be provided on time until a frame is complete; if the controlling processor does not do so, this is an "underrun error," and transmission of the frame is aborted. USARTs operating as synchronous devices used either character-oriented or bit-oriented mode.
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.