Search results
Results from the WOW.Com Content Network
An ATX motherboard Comparison of some common motherboard form factors (pen for scale). ATX (Advanced Technology Extended) is a motherboard and power supply configuration specification, patented by David Dent in 1995 at Intel, [1] to improve on previous de facto standards like the AT design.
Derived from the EEB and ATX specifications. This means that SSI CEB motherboards have the same mounting holes and the same IO connector area as ATX motherboards, but SSI EEB motherboards do not. SSI MEB: SSI? 411 × 330 mm (16.2 × 13 in) Created by the Server System Infrastructure (SSI) forum. Derived from the EEB and ATX specifications. microATX
FlexATX is a motherboard form factor derived from ATX.The specification was released in 1999 by Intel as an addendum to the microATX specification. It uses a subset of the motherboard mounting holes required for microATX and the same I/O plate system as ATX and microATX.
Comparison of the form factors for motherboards ATX, μATX (micro-ATX), DTX, mini-ITX and mini-DTX The DTX form factor is a variation of ATX specification [1] designed especially for small form factor PCs (especially for HTPCs) with dimensions of 8 × 9.6 inches (203 × 244 mm). [2]
ITX motherboard form factor comparison Comparison of the form factors for mini-ITX, mini-DTX, ATX, μATX and DTX motherboards. Mini-ITX is a 170 mm × 170 mm (6.7 in × 6.7 in) motherboard form factor developed by VIA Technologies in 2001. [1] Mini-ITX motherboards have been traditionally used in small-configured computer systems.
Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...
The mounting points of microATX motherboards are a subset of those used on full-size ATX boards, and the I/O panel is identical. Thus, microATX motherboards can be used in full-size ATX cases. Furthermore, most microATX motherboards generally use the same power connectors as ATX motherboards, [ a ] thus permitting the use of full-size ATX power ...
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).