enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Turnbuckle - Wikipedia

   en.wikipedia.org/wiki/Turnbuckle

   A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.

3. Threaded rod - Wikipedia

   en.wikipedia.org/wiki/Threaded_rod

   For studs that are not completely threaded, there are two types of studs: full-bodied studs, and undercut studs. Full-bodied studs have a shank equal to the major diameter of the thread. Undercut studs have a shank equal to the pitch diameter of the screw thread. Undercut studs are designed to better distribute axial stresses. In a full-bodied ...

4. Brinell scale - Wikipedia

   en.wikipedia.org/wiki/Brinell_scale

   The typical test uses a 10 mm (0.39 in) diameter steel ball as an indenter with a 3,000 kgf (29.42 kN; 6,614 lbf) force. For softer materials, a smaller force is used; for harder materials, a tungsten carbide ball is substituted for the steel ball. The indentation is measured and hardness calculated as:

5. Stud welding - Wikipedia

   en.wikipedia.org/wiki/Stud_welding

   Capacitor discharge weld studs range from 14 gauge to 3/8" diameter. They come in many different lengths, ranging from 1/4" to 5" and larger. They are usually manufactured from mild or stainless steel, brass, aluminium, and aluminium alloy. The tip on the weld end of the stud serves a twofold purpose:

6. List of welding codes - Wikipedia

   en.wikipedia.org/wiki/List_of_welding_codes

   Structural steel welding - Welding of steel structures AS/NZS 1554.2: Structural steel welding - Stud welding (steel studs to steel) AS/NZS 1554.3: Structural steel welding - Welding of reinforcing steel AS/NZS 1554.4: Structural steel welding - Welding of high strength quenched and tempered steels AS/NZS 1554.5

7. Safety wire - Wikipedia

   en.wikipedia.org/wiki/Safety_wire

   Safety wire is commonly 0.5, 0.6, 0.8 or 1 mm (0.020, 0.025, 0.032 or 0.041 in) in diameter, but 0.5-and-1 mm (0.021-and-0.051 in) diameters are also available. It is usually made of stainless steel, but is also available in monel and inconel alloys for high temperature applications and copper for break-away applications. [7]