Search results
Results from the WOW.Com Content Network
128-byte buffers. This UART can handle a maximum standard serial port speed of 921.6 kbit/s if the maximum interrupt latency is 1 millisecond. This UART supports 9-bit characters in addition to the 5- to 8-bit characters that other UARTs support. This was introduced by Oxford Semiconductor, which is now owned by PLX Technology.
Modern devices use an integrated circuit called a UART to implement a serial port. This IC converts characters to and from asynchronous serial form, implementing the timing and framing of data specified by the serial protocol in hardware. The IBM PC implements its serial ports, when present, with one or more UARTs.
Asynchronous start-stop is the lower data-link layer used to connect computers to modems for many dial-up Internet access applications, using a second (encapsulating) data link framing protocol such as PPP to create packets made up out of asynchronous serial characters. The most common physical layer interface used is RS-232D.
The 16550 UART (universal asynchronous receiver-transmitter) is an integrated circuit designed for implementing the interface for serial communications. The corrected -A version was released in 1987 by National Semiconductor . [ 1 ]
While it is common to illustrate serial protocol frames progressing in time from right to left, a reversed ordering is commonly practiced within the ARINC standard. Even though ARINC 429 word transmission begins with Bit 1 and ends with Bit 32, it is common to diagram [ 5 ] and describe [ 6 ] [ 7 ] ARINC 429 words in the order from Bit 32 to Bit 1.
x LPC protocol includes high overhead. While the gross data rate equals 33.3 million 4-bit-transfers per second (or 16.67 MB/s), the fastest transfer, firmware read, results in 15.63 MB/s. The next fastest bus cycle, 32-bit ISA-style DMA write, yields only 6.67 MB/s. Other transfers may be as low as 2 MB/s.
Distributed Network Protocol 3 (DNP3) is a set of communications protocols used between components in process automation systems. Its main use is in utilities such as electric and water companies. Its main use is in utilities such as electric and water companies.
Data rate versus line length chart, from RS-422 Annex A.1. Several key advantages offered by this standard include the differential receiver, a differential driver and data rates as high as 10 megabits per second at 12 meters (40 ft). Since the signal quality degrades with cable length, the maximum data rate decreases as cable length increases.